7 Tools for Protecting Your Walls
Patch up and fix up your old walls yourself with these helpful, easy tips!
Protect Your Walls from Cracks
Before driving a nail into a plaster wall, place a small piece of tape over the spot you’re working on. This simple prep step will prevent cracking in the plaster.
Patch It Up
To make a putty for quick patches, combine a tablespoon of salt with a tablespoon of cornstarch.
Mix them together with just enough water to make a paste. Apply while still wet.
Crafty Use for Old Gift Cards
In need of a thin yet sturdy household tool for scraping grout, repairing holes in walls, or filling scratches in wood? Use a used-up gift card (or expired credit card) for the job—any unusable hard plastic card will do. And if you’re anything like us, you have plenty of those!
Wall Hole Solution
You’re moving out of an apartment and need to fill in the holes in the wall caused by nails. Just grab a bar of white soap and rub across the hole until the soap fills it. It’s not a permanent fix, but it will make the walls look clean until they can be repainted.
Another Wall Hole Solution
Before spackling small holes in your wall caused by nails, first cut a Q-tip in half and insert in the hole, stick end first. Then spackle as you normally would. The Q-tip will completely fill the hole and ensure you won’t have to go back for a second pass.
Filling and sanding every hole in the wall before you paint can be enough of a pain, but sometimes it’s hard to find every crack, hole, and imperfection. Make your job easier by turning off the lights in a room, then slowly running a flashlight over the entire surface of the wall. The light will cast different shadows in these areas, making them easier to see than they would have been in the daylight.
Got a Screw Loose?
You’ve just struggled to remove a stripped screw from the wall. Now how do you fix the hole? Use a wooden golf tee! First, squirt some wood glue into the hole, then insert the tee as far as it will go, tapping it in place with a hammer. Next, use a utility knife to cut the tee flush with the wall. You’ve now made a stable base for the new screw. Drill a pilot hole into the golf tee, and insert your new screw. Problem solved!